Wall Kit 180 XT MAX Awning

180 XT MAX Wall Kit: turn your 180° awning into a fully enclosed room

Three main walls and a fourth front-or-rear wall zip, Velcro and peg onto the 180 XT MAX Awning to build an all-weather room. Run all four for a full enclosure, or just one or two as conditions change.

In the kit

• Three main walls, each with a large zippered midge-mesh window and an inner canvas flap that you can open fully, partly or close from inside.
• Roll-up door in the centre wall. Roll it up and tie it off with the toggles, or peg it out horizontally for extra shade (extra poles, pegs and ropes not supplied).
• Fourth wall that screens off the front or rear arm. Use it to block the wind, shelter the kitchen, or close the gap above the bonnet.
• Custom vinyl hanger for the privacy partition.
• Four aluminium telescopic poles extending to 2.6m, plus pegs.
• One heavy-duty canvas bag with YKK spiral zips for all four walls, and a separate canvas bag for the poles.

Using it

Clear night? Leave the walls in the bag. When the wind picks up, run one wall along the exposed side as a windbreak. When the weather really closes in, fit all four and you've got an enclosed room beside the vehicle, with somewhere dry to cook, eat and keep gear out of the rain. The mesh windows give you airflow and a view out while keeping the space private, and the inner canvas flaps shut them off when it's cold or wet.

The poles slot into the built-in holes in the trussed arms and take the weight of the walls and the extra wind load. On Mk2 awnings, a webbing loop sewn into the outer edge of the canvas at the end of each non-trussed arm takes a pole too. Older models get retrofit webbing straps, which can stay on the awning. Setting up and pegging down the full kit takes about 15 minutes.

For a private change room, shower or toilet area, fit the custom vinyl hanger around one of the trussed awning arms and hang any wall from it with Velcro, or run a wall along one of the non-trussed arms. With three walls you can make a triangular room at the front or rear without putting up the whole kit.

Walls pack into one zippered canvas bag and the poles into another, so they stay clean and tidy in a canopy, trailer or drawer system instead of living on the roof.

Made for Australian weather

The walls are 260gsm ±5% acrylic-treated polyester ripstop canvas, treated against mould, mildew and UV, and marks wipe off with warm water. 600gsm PVC mud skirts, over 400mm deep, seal the ground edge against water, dust and debris and wipe clean. The walls extend to 2.4m high, with reinforced tie-down points so you can set them to suit your vehicle. On rock where pegs won't go in, hold the skirt down with rocks. Panels join with YKK spiral zips, made from spiralled polyester and nylon, which is the softest, smoothest-running zip YKK makes, and they won't rust in salt air, sand or dirt. The total weight of the kit is 21kg including poles and pegs.

Fit

Cut for the 180 XT MAX, with panels and anchor points lined up to the awning, so no modifications are needed. The walls attach with the Velcro loop strip on the awning's valance, so the kit also suits any awning with a Velcro loop strip on its valance. 12-month warranty.

Only want one or two walls? The Universal Single Canvas Wall and Universal Single Mesh Wall suit any Bush Company awning and zip together along their sides for more coverage.

Shipped direct from The Bush Company.